AMT Datasouth ACCEL-6300 - Manual (Page 82)

User's Guide
Control Panel 4-19
Select Power-On Default Settings
DFALT lets you select the printer settings to use as the power-on default
settings. You can select the factory settings or the settings you saved
previously with a SAVE operation. The printer keeps your DFALT
selection in non-volatile memory so it is retained when the printer is off.
You can select Fctry to use the factory settings as the power-on de-
faults; or Usr 1 through Usr 5 to use the settings saved under one of
these names.
)Note: You can rename the five user areas so that they are more
mean-ingful to your particular applications. Refer to Changing User
Names in the Solving Problems section of this guide for more informa-
tion.
Run Printer Tests
TEST lets you run a variety of printer tests. If a test is unsuccessful, an
error message appears to notify you.
You can select None, which is always the default and does not perform
any test; Memory, which checks the printer memory; Sensor, which
runs the sensor check; Ribbon, which performs a ribbon alignment print
test; Align, which performs a printing alignment test; Pcalib, which re-
calibrates the sensitivity of the paper sensor; Random, which performs a
random carriage movement print test; or Gap, which prints the printhead
gap values measured across and around the surface of the platen.
Printer tests are described in detail in the Solving Problems section of
this guide.
)Note: Field service technicians use these printer tests to diagnose
problems and re-adjust the printer.
3) DFALT: Fctry
SETUP
MENU
I
O
4) TEST: None
User's Guide
Control Panel 4-19
Select Power-On Default Settings
DFALT lets you select the printer settings to use as the power-on default
settings. You can select the factory settings or the settings you saved
previously with a SAVE operation. The printer keeps your DFALT
selection in non-volatile memory so it is retained when the printer is off.
You can select Fctry to use the factory settings as the power-on de-
faults; or Usr 1 through Usr 5 to use the settings saved under one of
these names.
)Note: You can rename the five user areas so that they are more
mean-ingful to your particular applications. Refer to Changing User
Names in the Solving Problems section of this guide for more informa-
tion.
Run Printer Tests
TEST lets you run a variety of printer tests. If a test is unsuccessful, an
error message appears to notify you.
You can select None, which is always the default and does not perform
any test; Memory, which checks the printer memory; Sensor, which
runs the sensor check; Ribbon, which performs a ribbon alignment print
test; Align, which performs a printing alignment test; Pcalib, which re-
calibrates the sensitivity of the paper sensor; Random, which performs a
random carriage movement print test; or Gap, which prints the printhead
gap values measured across and around the surface of the platen.
Printer tests are described in detail in the Solving Problems section of
this guide.
)Note: Field service technicians use these printer tests to diagnose
problems and re-adjust the printer.
3) DFALT: Fctry
SETUP
MENU
I
O
4) TEST: None