AMT Datasouth ACCEL-6300 - Manual (Page 137)

User's Guide
6-20 Solving Problems
Table 6-1. Troubleshooting Guide––continued
Symptom Probable Cause/Corrective Action
Printer ejects cut sheets before 9 9 9 9 9 PGE END setting on Setup
finishing printing on page. menu is On. Change setting
to Off.
9 9 9 9 9 LENG setting on Setup menu
does not reflect actual length
of page in use. Change setting.
Forms jam in printer while using 9 9 9 9 9 Forms are snagging on print-
demand document mode. head during reverse feed.
Change DEMAND setting to
Tear and try again.
Control panel display goes blank 9 9 9 9 9 Static shock may have inter-
during printing. fered with display. When print
job is finished and printer is
idle, turn printer off, wait five
seconds, and turn printer back
on.
Paper park, demand document 9 9 9 9 9 PATH parameter on Setup
mode, or popup mode does not menu is set to TopTrac.
operate. Change setting to None.
User's Guide
6-20 Solving Problems
Table 6-1. Troubleshooting Guide––continued
Symptom Probable Cause/Corrective Action
Printer ejects cut sheets before 9 9 9 9 9 PGE END setting on Setup
finishing printing on page. menu is On. Change setting
to Off.
9 9 9 9 9 LENG setting on Setup menu
does not reflect actual length
of page in use. Change setting.
Forms jam in printer while using 9 9 9 9 9 Forms are snagging on print-
demand document mode. head during reverse feed.
Change DEMAND setting to
Tear and try again.
Control panel display goes blank 9 9 9 9 9 Static shock may have inter-
during printing. fered with display. When print
job is finished and printer is
idle, turn printer off, wait five
seconds, and turn printer back
on.
Paper park, demand document 9 9 9 9 9 PATH parameter on Setup
mode, or popup mode does not menu is set to TopTrac.
operate. Change setting to None.