AMT Datasouth ACCEL-6300 - Manual (Page 29)

User's Guide
1-2 Unpacking
Selecting a Good Place for the Printer––continued
9 9 9 9 9 Avoid outlets on the same circuit with large motors, such as copiers
or postage machines, or other appliances that might disturb the
power supply.
9 9 9 9 9 Leave several inches of empty space in front, behind, and on both
sides of the printer for good air flow.
9 9 9 9 9 Leave proper clearances for your paper loading needs.
Unpacking the Printer
To unpack the printer, use the following procedure:
1. Cut the packing tape and open the shipping carton.
2. Remove the components that are packed on top and around the
printer.
3. Grasp the front and back edges of the printer and lift the printer out
of the shipping carton.
4. Remove the foam end caps and place the printer on the site you
selected.
5. Remove the protective plastic covering from the printer.
6. Peel off the tape that secures the wire locking loops on the parallel
interface connector. The parallel interface connector is located on
the back of the printer.
7. If your printer has a powered, bottom-feed forms tractor, peel off
the tape that holds the pop-down supports in the raised position.
This tape is located on the lower sides of the printer.
8. Verify that you have all of the items shown in figure 1-1. If any-
thing is missing or damaged, contact the Dealer that sold you the
printer.
9. Fill in the Warranty Registration Card at the back of this guide and
mail it to AMT Datasouth. Returning this card ensures that you will
be notified of the latest printer news and enhancements.
10. Save the packing materials in case you need to ship the printer later.
User's Guide
1-2 Unpacking
Selecting a Good Place for the Printer––continued
9 9 9 9 9 Avoid outlets on the same circuit with large motors, such as copiers
or postage machines, or other appliances that might disturb the
power supply.
9 9 9 9 9 Leave several inches of empty space in front, behind, and on both
sides of the printer for good air flow.
9 9 9 9 9 Leave proper clearances for your paper loading needs.
Unpacking the Printer
To unpack the printer, use the following procedure:
1. Cut the packing tape and open the shipping carton.
2. Remove the components that are packed on top and around the
printer.
3. Grasp the front and back edges of the printer and lift the printer out
of the shipping carton.
4. Remove the foam end caps and place the printer on the site you
selected.
5. Remove the protective plastic covering from the printer.
6. Peel off the tape that secures the wire locking loops on the parallel
interface connector. The parallel interface connector is located on
the back of the printer.
7. If your printer has a powered, bottom-feed forms tractor, peel off
the tape that holds the pop-down supports in the raised position.
This tape is located on the lower sides of the printer.
8. Verify that you have all of the items shown in figure 1-1. If any-
thing is missing or damaged, contact the Dealer that sold you the
printer.
9. Fill in the Warranty Registration Card at the back of this guide and
mail it to AMT Datasouth. Returning this card ensures that you will
be notified of the latest printer news and enhancements.
10. Save the packing materials in case you need to ship the printer later.