Loading pin-feed paper, User's guide 3-6 loading paper – AMT Datasouth ACCEL-6300 User Manual
Page 51
User's Guide
3-6 Loading Paper
0
1
2
3
4
5
6
7
8
9
0
1
2
3
4
5
6
7
8
9
The printer contains two built-in, low-profile
tractors that are easy to load. Normally,
you load pin-feed paper from the back of
the printer. After loading paper, the printer
automatically advances the paper to the
first printable line. When printing is com-
pleted on the first page, the printer ad-
vances the paper to the next sheet, again to
the first printable line. This cycle continues
for as long as the paper supply lasts.
If your printer has bottom-feed forms
tractors, please refer to the Bottom-Feed
Tractors appendix in this guide for informa-
tion on loading paper from the bottom.
To load pin-feed paper in the printer, use
the following procedure:
1. Using the Paper Path button, select the
rear paper path ( ).
2. Raise the paper support and tractor
cover, as shown in figure 3-5.
3. Unlock both tractors by moving the lock-
ing levers, as shown in figure 3-6.
4. Slide the left-edge tractor as needed so
that the pin belt aligns with the circles
on the paper scale. Then, lock the left-
edge tractor into place, as shown in
figure 3-7.
5. Open both tractor doors.
Figure 3-5. Raising the Tractor Cover
Figure 3-7. Aligning the Left-Edge Tractor
Figure 3-6. Unlocking the Tractors
Loading Pin-Feed Paper
User's Guide
3-6 Loading Paper
0
1
2
3
4
5
6
7
8
9
0
1
2
3
4
5
6
7
8
9
The printer contains two built-in, low-profile
tractors that are easy to load. Normally,
you load pin-feed paper from the back of
the printer. After loading paper, the printer
automatically advances the paper to the
first printable line. When printing is com-
pleted on the first page, the printer ad-
vances the paper to the next sheet, again to
the first printable line. This cycle continues
for as long as the paper supply lasts.
If your printer has bottom-feed forms
tractors, please refer to the Bottom-Feed
Tractors appendix in this guide for informa-
tion on loading paper from the bottom.
To load pin-feed paper in the printer, use
the following procedure:
1. Using the Paper Path button, select the
rear paper path ( ).
2. Raise the paper support and tractor
cover, as shown in figure 3-5.
3. Unlock both tractors by moving the lock-
ing levers, as shown in figure 3-6.
4. Slide the left-edge tractor as needed so
that the pin belt aligns with the circles
on the paper scale. Then, lock the left-
edge tractor into place, as shown in
figure 3-7.
5. Open both tractor doors.
Figure 3-5. Raising the Tractor Cover
Figure 3-7. Aligning the Left-Edge Tractor
Figure 3-6. Unlocking the Tractors
Loading Pin-Feed Paper