Unpacking – AMT Datasouth ACCEL-6300 User Manual
Page 28
User's Guide
Unpacking 1-1
Unpacking
This section describes how to select a good place for the printer and
unpack it. If the printer is already set up, you can skip ahead to the
next section.
Selecting a Good Place for the Printer
When selecting a place for your printer, observe the following guidelines:
9
9
9
9
9 The site must be large enough to accommodate the printer. For
narrow-carriage models, the site must be at least 21 inches (54 cm)
wide by 19 inches (49 cm) deep. For wide-carriage models, the site
must be at least 26 inches (66 cm) wide by 19 inches (49 cm) deep.
9
9
9
9
9 The printer must be close enough to the computer for your cable to
reach: 10 feet (3 meters) for parallel or 50 feet (15 meters) for
serial.
9
9
9
9
9 The printer must be on a flat, solid surface—never on a chair or any
other unstable support.
9
9
9
9
9 Choose a place that is clean and free from excessive heat (including
direct sunlight), moisture, and dust.
9
9
9
9
9 Use a grounded outlet—one that has three holes to match the power
plug on the printer. Don't use an adapter plug or an extension cord.
Section
1
User's Guide
Unpacking 1-1
Unpacking
This section describes how to select a good place for the printer and
unpack it. If the printer is already set up, you can skip ahead to the
next section.
Selecting a Good Place for the Printer
When selecting a place for your printer, observe the following guidelines:
9
9
9
9
9 The site must be large enough to accommodate the printer. For
narrow-carriage models, the site must be at least 21 inches (54 cm)
wide by 19 inches (49 cm) deep. For wide-carriage models, the site
must be at least 26 inches (66 cm) wide by 19 inches (49 cm) deep.
9
9
9
9
9 The printer must be close enough to the computer for your cable to
reach: 10 feet (3 meters) for parallel or 50 feet (15 meters) for
serial.
9
9
9
9
9 The printer must be on a flat, solid surface—never on a chair or any
other unstable support.
9
9
9
9
9 Choose a place that is clean and free from excessive heat (including
direct sunlight), moisture, and dust.
9
9
9
9
9 Use a grounded outlet—one that has three holes to match the power
plug on the printer. Don't use an adapter plug or an extension cord.
Section
1