AMT Datasouth ACCEL-6300 User Manual
Page 131
User's Guide
6-14 Solving Problems
Table 6-1. Troubleshooting Guide––continued
Symptom
Probable Cause/Corrective Action
Printing is smearing.
9
9
9
9
9 Print density fine-adjustment
is set too dark. Hold down
Print Density button and re-
adjust print density.
9
9
9
9
9 PH GAP and PFORCE param-
eters on Setup menu are not
set to Auto, or settings are
incorrect. Check settings.
9
9
9
9
9 Ribbon is tangled. Correct
problem or replace ribbon
cartridge.
9
9
9
9
9 Small piece of paper or debris
is lodged in front of printhead.
Remove obstruction.
9
9
9
9
9 Paper is not taut between the
tractors or around the platen.
Reload paper.
Large portions of characters are
9
9
9
9
9 Ribbon is tangled. Correct
not printing.
problem or replace ribbon
cartridge.
User's Guide
6-14 Solving Problems
Table 6-1. Troubleshooting Guide––continued
Symptom
Probable Cause/Corrective Action
Printing is smearing.
9
9
9
9
9 Print density fine-adjustment
is set too dark. Hold down
Print Density button and re-
adjust print density.
9
9
9
9
9 PH GAP and PFORCE param-
eters on Setup menu are not
set to Auto, or settings are
incorrect. Check settings.
9
9
9
9
9 Ribbon is tangled. Correct
problem or replace ribbon
cartridge.
9
9
9
9
9 Small piece of paper or debris
is lodged in front of printhead.
Remove obstruction.
9
9
9
9
9 Paper is not taut between the
tractors or around the platen.
Reload paper.
Large portions of characters are
9
9
9
9
9 Ribbon is tangled. Correct
not printing.
problem or replace ribbon
cartridge.