AMT Datasouth ACCEL-6300 User Manual

Page 134

Advertising

User's Guide

Solving Problems 6-17

Table 6-1. Troubleshooting Guide––continued

Symptom

Probable Cause/Corrective Action

Multipart forms or labels tear

9 Print density fine-adjustment

during printing. Or, labels peel

is set too dark. Hold down

off the backing sheet during

Print Density button and re-

printing.

adjust print density.

9 PH GAP and PFORCE param-

eters on Setup menu are not
set to Auto, or settings are
incorrect. Check settings.

9 Forms or labels are too thick

to feed around platen. If media
is pin-feed and you have a top-
mounted pull tractor option, or
your printer has bottom-feed
tractors, try feeding forms from
bottom of printer.

Printing goes off right side of page. 9

9 WIDTH setting on Setup menu

is incorrect. Check setting.

Lines of text print on top of one

9 AUTO LF mode on Setup

another.

menu is off. Turn it on.

9 Paper is not taut between trac-

tors or around platen. Reload
paper.

9 Wrong paper path selected.

Check paper path selection.