Watlow CPC400 - Manual (Page 19)

CPC400 Series User’s Guide Chapter 1: System Overview
Doc. 0600-2900-2000 Watlow Anafaze 5
Figure 1.1 CPC400 Standard Parts List
40 _ -1 _ _ _ _ _ _
Number of Loops
4 = 4 loops
8 = 8 loops
Controller Type
1 = Standard firmware
Terminal Block
0 = No terminal block accessory
1 = 18-terminal block
2 = 50-terminal block, includes 3-foot (0.9 m) 50-pin SCSI cable (TB50-SCSI)
Power Supply
0 = No power supply
2 = 120/240V
Å (ac), 50/60 Hz power supply adapter
(5V Î [dc] @ 4 A, 15V Î [dc] @ 1.2 A), CE approved
SCSI Cables (for use with TB50-SCSI)
0 = No special SCSI cable (3-foot [0.9 m] cable is included with 50-terminal block)
1 = 6-foot (1.8 m) SCSI cable (CA-SCSI-6)
2 = 3-foot (0.9 m) right-angle SCSI cable (CA-SCSI-RT-3)
3 = 6-foot (1.8 m) right-angle SCSI cable (CA-SCSI-RT-6)
Serial Cables (for communications with computer)
0 = No serial communications cable
1 = 10-foot (3.0 m) serial cable, DB-9 female/bare wire (CA-COMM-010)
2 = 25-foot (7.6 m) serial cable, DB-9 female/bare wire (CA-COMM-025)
3 = 50-foot (15.2 m) serial cable, DB-9 female/bare wire (CA-COMM-050)
Serial Communications Jumper Settings
0 = EIA/TIA-232
1 = EIA/TIA-485
2 = EIA/TIA-485 terminated
Special Inputs
Standard unit is configured for thermocouples and -10 to +60mV process inputs.
For other sensors, special inputs are required.
0 = Thermocouples and -10 to +60mV inputs only
X = Number of current and voltage inputs.