Watlow CPC400 - Manual (Page 70)

Chapter 3: Operation and Setup CPC400 Series User’s Guide
56 Watlow Anafaze Doc. 0600-2900-2000
Accessing and Navigating the Setup Menus
Use the setup menus to configure the controller. For a list
of all setup menus and parameters, refer to Figure 5.2 on
page 95.
How to Access the Setup Menus
To access the setup menus, press and hold x for three sec-
onds, until the Global setup menu appears.
To prevent unauthorized personnel from accessing setup
parameters, the controller reverts to the regular display if
you do not press any keys for three minutes.
How to Edit a Setup Parameter
To edit a setup parameter, go to the appropriate setup
menu, go to the parameter, then edit the value:
1. Press and hold x for three seconds to access the setup
menus.
2. Press < to go to the appropriate a menu.
3. If applicable, press p to choose the loop that you
want to edit.
4. Press . to go to the parameter that you want to edit.
5. To edit a parameter:
• Press < or > to choose a value.
• Press . to save the new value and go to the next
parameter.
• Press x to cancel a change without saving.
6. Repeat from step 4 to edit another parameter in the
current menu.
7. Press x to return to the top-level menus.
8. Repeat from step 2 to go to another menu, or press x
to exit the setup menus.
For information about setting parameters through serial
communications or LogicPro programs, see Setting Param-
eters Through Serial Communications or a LogicPro Pro-
gram on page 78.