Yokogawa digitalYEWFLO (DY) - Manual (Page 29)

QUICK START USING THE BT100/200
IM 1F2B4-01-YIA
Page 25
2.2 YEWFLO S
ETUP
Note: If you specified the correct process conditions on your order, these parameters have been preset at the
factory; therefore, there is no need to re-enter the data.
The purpose of a Quick Start is to address only those parameters which must be set to establish the
operation of a meter for this application. Follow the parameters listed below and enter the data for
your particular application.
With the BT100 or BT200 properly connected to the Vortex meter begin communicating by pressing
the power button. After the power up sequence is complete, go to “ Menu B: SET 1”. The operation of
the BT100 and BT200 are slightly different. Please refer to the ‘Basic Handheld Terminal Operation’
if you are unfamiliar with how to move through the menus and parameters. The following flow chart
identifies only the parameters to be set, you may have to skip several parameters or menus to get to
the parameters shown below. Be sure to enter all values and selections shown below or they will
not be saved. If you make a typing error, use the CLR key to clear and re-enter.