Yokogawa JUXTA M Series Digital Limit Alarms MVTK User Manual
User’s manual
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- Introduction
- Documentation Conventions
- Notices
- CONTENTS
- 1. Setup
- 2. Communication Specifications
- 3. PC Link Communication
- 3.1 Overview
- 3.2 Commands
- 3.2.1 List of Commands
- BRD Reads I relays on a bit-by-bit basis
- BWR Writes data into I relays on a bit-by-bit basis
- BRR Reads I relays on a bit-by-bit basis in random order
- BRW Writes data into I relays on a bit-by-bit basis in random order
- BRS Specifies I relays to be monitored on a bit-by-bit basis
- BRM Monitors I relays on a bit-by-bit basis
- WRD Reads D registers and I relays on a word-by-word basis
- WWR Writes data into D registers and I relays on a word-by-word basis
- WRR Reads D registers and I relays on a word-by-word basis in random order
- WRW Writes data into D registers and I relays on a word-by-word basis in random order
- WRS Specifies D registers and I relays to be monitored on a word- by-word basis
- WRM Monitors D registers and I relays on a word-by-word basis
- INF Reads the model, range code number, number of alarms and revision
- 3.2.1 List of Commands
- 3.3 Communication with Higher-level Devices
- 4. Ladder Communication
- 5. MODBUS Communication
- 6. Functions and Usage of D Registers
- 7. Functions and Usage of I Relays
- Appendix Table of ASCII Codes (Alphanumeric Codes)
- Revision Information