Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) - Manual (Page 535)

Unified IP MIB Reference 509
53-1003106-01
OSPF area table
50
OSPF area table
The OSPF area data structure contains information that describes the various OSPF areas. The
interfaces and virtual links are configured as parts of these areas. Area 0.0.0.0, by definition, is the
Backbone Area.
snOspfExtLsdbLimit
brcdIp.1.2.4.1.11
Syntax: Integer32 Read-write Provides compliance with RFC 1765 in the handling of OSPF external
link-state database (LSDB) overflow.
Specifies the maximum number of non-default AS-external-LSAs
entries that can be stored in the link-state database. When the number
of non-default AS-external-LSAs in a router’s link-state database
reaches ospfExtLsdbLimit, the router enters overflow state.The router
never holds more than ospfExtLsdbLimit non-default AS-external-LSAs
in its database. OspfExtLsdbLimit must be set identically in all routers
attached to the OSPF backbone and any regular OSPF area. OSPF stub
areas and NSSAs are excluded.
Valid values: 1 – 2000.
NOTE: There is not limit, if the value is -1.
snOspfExitOverflowInterv
al
brcdIp.1.2.4.1.12
Syntax: Integer Read-write Specifies the number of seconds that a router will attempt to leave the
overflow state. This value allows the router to again originate
non-default AS-external-LSAs. If this object is set to 0, the router will
not leave the overflow state until it is restarted.
Valid values: 0 – 86400 seconds
snOspfRfc1583Compatibi
lity
brcdIp.1.2.4.1.13
Syntax: Integer Read-write Specifies if the OSPF route is compatible with RFC 1583 or RFC 2178:
•
disabled(0) – Compatible with RFC 2178.
•
enabled(1) – Compatible with RFC 1583.
snOspfRouterIdFormat
brcdIp.1.2.4.1.14
Syntax: Integer Read-write Specifies the format of how the router ID will be entered in the
“snOspfRouterId” object:
•
integer(0) – Integer
•
ipAddress(1) – IP address
snOspfDistance
brcdIp.1.2.4.1.15
Syntax: Integer Read-write Determines the OSPF administrative distance area. The value is zero is
the distance is not set.
Valid values: 1 – 255
Default: 110
snOspfDistanceIntra
brcdIp.1.2.4.1.16
Syntax: Integer Read-write Determines the OSPF administrative distance for intra-area routes.
Valid values: 1 – 255
Default: 110
snOspfDistanceInter
brcdIp.1.2.4.1.17
Syntax: Integer Read-write Determines the OSPF administrative distance for inter-area routes.
Valid values: 1 – 255
Default: 110
snOspfDistanceExternal
brcdIp.1.2.4.1.18
Syntax: Integer Read-write Determines the OSPF administrative distance for external routes.
Valid values: 1 – 255
Default: 110
Name, OID, and syntax Access Description