Brocade Unified IP MIB Reference (Supporting FastIron Releases 07.5.00 and 08.0.10) - Manual (Page 83)

Unified IP MIB Reference 57
53-1003106-01
draft-ietf-idr-bgp4-mibv2-12 MIB
2
BGP4v2 NLRI table
The following table contains the BGP4v2 Network Layer Reachability Information (NLRI) objects.
Use the show ip bgp routes detail command to display all the BGP attributes of a route, such as
communities. Use the show ip bgp routes command to display the entries learned through NLRI
available in the update.
NOTE
The following table is not supported on the Brocade NetIron CES 2000 series BASE Packages device.
Name, OID, and syntax Access Description
bgp4V2PeerEventTimesTable
brcdIp.3.5.1.1.4 None A table reporting the per-peering session amount of time
elapsed and update events while the peering session
advanced into the established state.
bgp4V2PeerFsmEstablishedTime
brcdIp.3.5.1.1.4.1.1
Syntax: Gauge32 Read-only Indicates how long (in seconds) the peer has been in the
established state or how long since the peer was last in the
established state. The value of the object is set to zero(0)
when a new peer is configured or when the router is booted.
The value remains zero if the peer has never reached the
established state.
bgp4V2PeerInUpdatesElapsedTime
brcdIp.3.5.1.1.4.1.2
Syntax: Gauge32 Read-only Indicates the elapsed time (in seconds) since the last BGP
update message was received from the peer. The value of the
object is set to zero(0) each time bgpPeerInUpdates is
incremented.
Name, OID, and syntax Access Description
bgp4V2NlriTable
brcdIp.3.5.1.1.9 None The BGP4v2-received path attribute table contains
information about paths to destination networks received
from all the BGP4 peers. Collectively, this represents the
Adj-Ribs-In. For NLRI, the route in which the bgp4V2NlriBest
object is true represents the route that is installed in the
LocRib from the Adj-Ribs-In.
bgp4V2NlriIndex
brcdIp.3.5.1.1.9.1.1
Syntax: Unsigned32
NOTE: This object is not supported
on Brocade NetIron MLX,
Brocade MLXe, Brocade
NetIron XMR, Brocade
NetIron CES, and Brocade
NetIron CER series devices
None Specifies the index that allows multiple instances of a base
prefix for a certain AFI-SAFI from a given peer. This is used to
allow a peer in future implementations to send more than a
single route instance and allow extensions that extend an
NLRI field to send the same prefix while utilizing other
extension-specific information.
The index is always 1.
bgp4V2NlriAfi
brcdIp.3.5.1.1.9.1.2
Syntax:
Bgp4V2AddressFamilyIdentifierTC None Specifies the address family of the prefix for NLRI.
NOTE: It is not necessary that an AFI definition is equivalent
to an InetAddressType.
bgp4V2NlriSafi
brcdIp.3.5.1.1.9.1.3
Syntax:
Bgp4V2SubsequentAddressFamilyI
dentifierTC None Specifies the subsequent address family of the prefix for
NLRI.