Hired-Hand Mega-Cool rev 4-08 - Manual (Page 17)

Part No. 4801-5093 Rev 4-08 Unitized System Page 17
Install BackPlate
1. Refer to diagram at left. At end post of system on opposite end from float valve, measure dimension
"A" as shown and mark post. See the Framing Diagram on Pages 7 and 8 for dimension “A”.
2. At the other end post of system (end post at float valve side of system) measure dimension "A"
minus one inch (2.5 cm) and mark post. This provides a 1” drop for proper water flow.
3. Stretch chalk line between marks of end posts and mark all posts of system.
4. For each post of system, align top edge of BackPlate with mark on post. Assemble BackPlate as
shown in diagram at left. Securely mount BackPlate on centers of 4x4" posts, not more than 5 ft.
(1.52 m) O. C. (on center).
5. Secure BackPlate to wooden framing with #10 x 1" Hex Head screws, or secure Backplate to steel
framing with #12 x 1" Hex Head TEK screws.
BackPlate
Side View
Assembly of
BackPlate
(1) Install top of BackPlate.
(2) Hook BackPlate Supports in bottom
holes of BackPlate. There are 3 Supports
per BackPlate. One on each end and one
in the middle.
(3) Rotate BackPlate Support Brackets up
into position.
(4) Attach with screws.
1
2
3
4
“A”