Drill holes in drive pipe for drive insert – Hired-Hand Mega-Cool rev 4-08 User Manual
Page 50
Advertising
Part No. 4801-5093 Rev 4-08
Unitized System
Page 50
Drill Holes in Drive Pipe for Drive Insert
1.
Measure 1" (2.54 cm) from one end of drive pipe. Mark pipe. Measure
2 1/2" (6.35 cm) from end of pipe in line with first mark. Mark pipe.
2.
Drill a 3/8" (0.95 cm) hole in pipe at each mark.
1"
(2.5 cm)
2 1/2"
(6.4 cm)
Drive pipe
Advertising
This manual is related to the following products: