Hired-Hand Mega-Cool rev 4-08 - Manual (Page 40)

Part No. 4801-5093 Rev 4-08 Unitized System Page 40
Tubular Motor
1. Before sliding motor into drive pipe, measure distance from end of motor to
end of motor tube. This distance is labeled as R in detail b above.
1. Slide tubular motor into the slotted end of the drive pipe until the raised key of
the motor head seats into the notch. (see detail a)
2. As shown in detail b, drill several 3/16 in. (4.8 mm) holes around the
circumference of pipe at distance R (measured in step 1). Install stainless steel
pop rivets into the holes to fasten motor tube.
b
CAUTION!
Do not drill into motor
When installing pop rivets.
a
NOTE: Dimensions
of slot in millimeters.
To convert to inches
multiply
mm by 0.0394.
NOTE: At this point of the installation, the drive pipe may be installed onto the guide brackets.
REFER TO SECTION - 'PLACEMENT OF DRIVE PIPE INTO GUIDE BRACKETS'. After
installing drive pipe, return to Section - 'Attachment Of Tubular Motor To Motor Mount'.