Hired-Hand Mega-Cool rev 4-08 - Manual (Page 57)

Part No. 4801-5093 Rev 4-08 Unitized System Page 57
Placement of the Drive Pipe into the Guide Brackets if Assembled on the
Ground
1. After fastening pipe sections together and installing motor, lift drive pipe assembly and place it onto guide brackets at
the top of the track units. and installing motor, lift drive pipe assembly and place it onto guide brackets at the top of
the track units.
NOTE: The drive pipe is heavy and will require several workers to lift it into position.
CAUTION! Do not attempt to lift the drive pipe without a sufficient number of workers.
2.
For installation of very long drive pipes it may be necessary to leave one or more junctions of the drive pipe
unattached to create lighter drive pipe sections that can be more easily lifted onto the guide brackets. Connect the
loose junctions with pop rivets after the drive pipe is placed onto guide brackets.
Drive pipe
Not e: The drive pipe assembly is
heavy! Make sure t hat t here are
sufficient number of workers t o lift t he
drive pipe ont o t he guide bracket s.
Lift drive pipe assembly and
place ont o t he guide bracket s
t he t op of t he t rack unit s.
Drive pipe