Add ball valve to end, Float valve assembly – Hired-Hand Mega-Cool rev 4-08 User Manual
Page 27
Advertising
Part No. 4801-5093 Rev 4-08
Unitized System
Page 27
Add Ball Valve To End
1. Install 1-1/2" (3.8 cm) x 1-1/4" (3.17 cm) reducing coupling to opposite end of spray line.
2 Glue ball valve to end of system.
NOTE: If a Center-Mount In-Line Pump System is being installed, a ball valve and coupling must
be placed on both ends of the system. Refer to the Center-Mount System Diagram on Pages
25 and 29.
Float Valve Assembly
1. Screw water supply hose onto fitting.
2. Use slot in bracket to adjust water level. If slot is not enough adjustment, remove cover and move float
arm to another position.
Ball Valve
1-1/4" (3.8 cm) to 1-1/2"
(3.17 cm) reducing coupling
Advertising
This manual is related to the following products: