Star Water Systems SJ10 - Manual (Page 5)

5
95 North Oak Street • Kendallville, IN 46755 • © 2014 Star Water Systems. All rights reserved.
2
GeNeRAl pUMp iNFORMATiON
pRepARATiON
Before beginning installation of product, make sure all parts are present. If any part is missing or
damaged, do not attempt to assemble the product. Compare parts to package contents list and
hardware contents list.
Estimated Installation Time: 2 hours.
Tools Required for assembly (not included): pipe wrench, pliers, Phillips screwdriver, pipe clamp, 2-step
PVC glue system (primer and sealer), thread tape
Parts Required for assembly (not included):
1-1/4 in. to 1 in. male PVC adapter, 1-1/4 in. male PVC
adapter, 1 in. male PVC adapter, 1 in. foot valve, 1-1/4 in. PVC pipe, 1 in. PVC pipe, 1-1/4 in. PVC
elbow, 1 in. PVC elbow, 1 in. discharge tee, galvanized bushing, pressure gauge or pipe plug, electrical
wire strain relief (2), 1 in. close nipple, 1 in. x 5 in. pipe nipple
Typical pump Setup
Convertible jet pumps are designed for use in
these applications:
1. Shallow wells (0 - 25 ft. lift) where ejector bolts
to pump.
2. Deep wells (0 - 40 ft. lift) where well inside
diameter is 4 in. or more and ejector is
installed in the well.
1
Discharge
to
Home
Water Level
1-1/4 in. Foot Valve
1 in.
Discharge Pipe
1 in.
Suction Pipe
Suction
Lift
25 ft.
Max.
1-1/4 in. x 1 in. Male Adapter
Discharge
to
Home
Water Level
1-1/4 in. Foot Valve
1 in.
Discharge Pipe
1-1/4 in.
Suction Pipe
Suction
Lift
40 ft.
Max.
1 in.
Pressure Pipe
1 -1/4 in. to 1 in. Male Adapter
1 in. Pipe