Triton FT5000XP Prism NDC Emulation w/XFS Compliance User Manual - Manual (Page 34)

30
M
odel
rl/Ft5000 XP U
Ser
M
anUal w
/P
riSM
tM ndc e
MUlation
8. If the paper is not automatically
taken-up by the printer, check the
tension roller lever on the printer
chassis. Pull the pin located on the
right side of the printer bracket
shown. Rotate the assembly
towards the front of the control
panel.
9. The blue tension lever is located
on the left side. It must be in
the closed position (blue lever
facing towards the right). If not,
just move the lever (moves in 3
positions) to the correct position.
Close the cutter assembly and
retry to feed the printer paper. If
successful, continue with Step
10. If the paper is not taken
up automatically, contact your
service provider.
10. Make sure the supervisor switch
is in the S
UPerviSor
position and
then close the control panel. From
the Prism TM NDC Supervisor
main menu (S
elect
), select
c
onFigUre
> P
rint
c
onFig
to
perform an offline test of the
printer.
11. Open the control panel and flip
the supervisor switch to the r
Un
position. Close and lock the
control panel.
Release pin