Triton FT5000XP Prism NDC Emulation w/XFS Compliance User Manual - Manual (Page 38)

34
M
odel
rl/Ft5000 XP U
Ser
M
anUal w
/P
riSM
tM ndc e
MUlation
4. Direct the paper (item 6) from the paper roll (item 4) through the Paper Out
Sensor and down into the Guide slot (item 7) until the paper stops against
the Feed Mechanism (item 8). Remove the Journal Take-up Carriage (item
9).
5. The paper is now ready to be advanced automatically through the rest
of the printer assembly. First, turn the power switch ON. After a few
seconds, press the Feed Switch until the Feed Mechanism (item 8) passes
approximately 5-7 inches of paper beyond the Bail (item 3). You may need
to apply hand pressure on the paper, directed towards the Feed Mechanism
(item 8), in order to activate the Feed Mechanism (item 8).
6. Lift the Bail (item 3) and pull the journal paper (item 6) out of the Bail
Slot (item 10).
7. Guide the journal paper (item 11) through the Journal Slot (item 12).
Attach the leading edge to the clip on the Journal Take-up carriage (item
9).
Steps 8 and 9 redirect the journal paper to the Journal Take-up carriage.
8. Advance the Journal Take-up Carriage (item 9) by hand until the journal
paper (item 11) is taut.
9. Attach the Journal Take-up Carriage (item 9) to its mounting bracket.
10. The journal paper is now loaded.
Figure 6-2. Loading journal paper.