Triton FT5000XP Prism NDC Emulation w/XFS Compliance User Manual - Manual (Page 54)

50
m
oDel
rl/Ft5000 XP U
Ser
m
AnUAl w
/P
riSm
tm nDc e
mUlAtion
DISP CONFIG: Displays all the configure parameter settings.
PRNT CONFIG: Prints all the configure parameter settings. The printer or
printers used is configured using the “CONFIGURE - SET PRINT” function.
TRACK 1: Sets up the format for Track1 Name display – not currently
supported.
ROLL WIDTH: Provides configuration for the number of columns printed
on the receipt and the starting left column. This function will prompt for both
the number of columns and the left column to start printing from. The two
entered values must not exceed 41.
MACHINE NO: Prompts for entry of the 6 digit machine number. This number
is then used in all messages sent to the host (if appropriate configuration) and
in the default print on the deposit envelope.
DATE/TIME: Prompts for the date and time in the format displayed. The
system data and time will be changed to the entered values
MSG MODE: Miscellaneous option parameters – not currently supported
DISP SCRN: Displays all screens in the NDC screens library. This option
is only supported when the supervisor interface is using the front customer
screen. Press <e
nter
> continuously to view consecutive screens, otherwise
select a specific screen by entering the screen number at the prompt.
SET PRINT: Prompts for a printer configuration to use when printing data
in Supervisor Mode from either the front customer screen or from the rear
operator panel. Valid values are:
3.3 Configure Menu