Triton FT5000XP Prism NDC Emulation w/XFS Compliance User Manual - Manual (Page 66)

62
m
oDel
rl/Ft5000 XP U
Ser
m
AnUAl w
/P
riSm
tm nDc e
mUlAtion
A
cceSS
i
nStrUctionS
:
1. Enter the S
UPerViSor
m
oDe
by opening the control panel. The Supervi-
sor “S
elect
” menu should appear on the display.
2. Refer to the applicable Figures below (by model type). Lock the Prism
NDC application in “S
UPerViSor
m
oDe
” by depressing the “Supervi-
sor” rocker switch so the raised RED edge on one side of the switch
is NOT visible. This will prevent the Prism TM NDC emulation applica-
tion from exiting to the “c
UStomer
(r
Un
) m
oDe
”. In the RL5000 XP or
the FT5000 XP , the “Supervisor” switch is located on the Controller PC
mounting bracket.
FT5000 XP
Supervisor
Switch - Raised
Red Edge
RL5000 XP
Supervisor Switch -
Raised Red Edge
SUPERVISOR MODE