GW Instek PSB-2000 Series User Manual - Manual (Page 121)

EXTERNAL CONTROL
121
External Control of the Current Output ON/OFF
(:EXT:CURR)
This command chooses whether the external control is used to
control the output current or if the front panel controls are used to
control the output current.
Setting :EXT:CURR <value>
Activates or deactivates external control of the output
current of a single channel model.
:EXT:CURR:A <value>
Activates or deactivates external control of the output
current of CH1.
:EXT:CURR:B <value>
Activates or deactivates external control of the output
current of CH2.
<value> is as shown below:
0: Deactivates external control of the output current
(Allows the current output to be controlled with the front
panel controls or via remote control).
1: Activates external control of the current output.
Application
example :EXT:CURR 1
Selects the external control of the current output.
Query :EXT:CURR?
Inquires about the setting.
Response
example 1
Indicates that external control of the current output is
enabled. The query return value has the same meaning as
the setting <value>.
Remark This command causes an error during sequence
operation (RUN).
Output switching (:EXT:OUTP)
This command selects output On/Off with external contacts.
Setting :EXT:OUTP <value>
<value> is as shown below:
0: Control from the panel or through communication
1: Output On/Off with external contacts
Application
example :EXT:OUTP 1
Selects output On/Off with external contacts.
Query :EXT:OUTP?
Inquires about the setting.