GW Instek PSB-2000 Series User Manual - Manual (Page 62)

PSB-2000 Series User Manual
62
○ ○ ○
―● SEQUENCE―
4. Next, set the Start Step number with the
encoder wheel.
Press the ENTER /
CHECK key to confirm.
The setting range is from 0 to 99.
Example: The Start Step is set to No. ―00‖.
5. Set the End Step number with the encoder
wheel.
Press the ENTER /
CHECK key to confirm.
The setting range is from 0 to 99.
Example: The End Step is set to step No. ―99‖.
6. Set the number of times to repeat the steps
above with the encoder wheel.
Press the ENTER /
CHECK key to confirm.
Setting the sequence function is now complete.
The ―---― setting repeats the steps infinitely.
The setting range is from 1 to 999 or ―—―
(infinite).
Example: Repeat the selected steps 999 times.
7. Press the ESC / DISP key to quit the Sequence
settings and enter the sequence operation