GW Instek PSB-2000 Series User Manual - Manual (Page 42)

PSB-2000 Series User Manual
42
Various Settings
Turning the Power On
Introduction First, press the POWER switch to turn on the
power. The power supply unit will show the
startup screen (firmware version and models) for
several seconds and then displays the last-used
settings.
Note
The unit saves the last-used settings automatically
when the power supply source is cut off or the
POWER switch is shut off.
Model PSB-2400L,
version 1.00 The last-used
settings are
displayed
How to Set the Voltage
Procedure 1. Make sure that the V key is lit green. If not,
press the V key to turn it on.
V A W
2. Set the voltage level with the encoder wheel.
Note Check which channel is selected before setting the
voltage on the PSB-2400L2 in order not to change
the set value of the other channel.