GW Instek PSB-2000 Series User Manual - Manual (Page 50)

PSB-2000 Series User Manual
50
The diagram below can be used as a reference for the menu
operations in the following pages:
General Setting
Procedure 1. Press the MENU key until an intended function
number is displayed.
2. Press the ENTER/ CHECK key to validate the
function. Proceed to setting of the next item.
3. Set a numeric value or item with the encoder,
and press the ENTER/ CHECK key to validate it.
4. When all intended items have been set, press
the ESC/ DISP key to return to the normal state.
CAUTION Set values are only validated after the ENTER /
CHECK key is pressed.
Be sure to check that the value is set properly after
setting it.
Some functions may not be settable as some
functions cannot be used together. See the table
below for details.
Set function
Functions that cannot be set or
used simultaneously
Preset
Sequence
External(voltage/resistance)
OVP/OCP -
Hi-Ω (PSB-L Series Only) -
Off timer
Sequence Delay External
(On/Off)
Voltage LED
Current LED
2 digit LED for displaying the number of cycles,
step No., and menu No.