Badger Meter Vortex Meters - Manual (Page 10)

Page 8
eDiT/in-seRviCe Menu
Entering Edit Mode and Putting Meter In-Service
FL_METER
0
4
0
72
0
RWG15
Tag:
PV (Volume)
Model Number:
Analog Output Current:
Percent of Range:
Process Temperature:
Process Pressure:
ft3/min
mA
%
degF
psi
Connect Connect Update
Begin Continuous Display Update
Racine Federated HART Interface Utility
Tools Configure Meter About Com Port Save/Restore Configuration Edit/In-Service Edit/In-Service
Enter Edit Mode
Put Meter In Service
Put Meter In Service
Edit Mode
Indicator
Meter In-Service
Indicator
Continuous Screen Update:
Meter In-Service:
Edit Mode:
Fixed Current Value:
Configuration Changed, Not Saved:
Password Protection:
NOTE: Save the changes to EEPROM and put the meter in-service after making changes.
Entering Edit Mode - The user must put the meter in edit mode before any changes can be
made to the meter’s settings. There are two ways to enter edit mode. The first way is to click
the “Edit/In-Service” pull-down menu on the Main screen and select “Enter Edit Mode”. The
second way is to simply attempt to change the settings and the user will be prompted to enter
edit mode.
in-service indicator - The “Meter In-Service” indicator is lit when the meter is in-service. No
setting can be changed when the meter is in-service.
edit Mode indicator - The “Edit Mode” indicator is lit when the meter is in edit mode. Settings
in the meter can be changed while in edit mode, except the analog output current. It is not
changed while the meter is in edit mode, put the meter back in-service after making changes to
the meter.