Agilent Technologies Agilent B2201A - Manual (Page 152)

5-24 Agilent B2200 User’s Guide, Edition 4
SCPI Command Reference
[:ROUTe]:AGND:CHANnel:DISable:CARD
Example OUTPUT @Agb2200;":DIAG:TEST:FRAM:STAT? CONT"
ENTER @Agb2200;A
[:ROUTe]:AGND:CHANnel:DISable:CARD
This command ground-disables the all output ports (channels) for the specified card.
When the Ground Mode is ON, the ground-disabled output ports are disconnected
from the input Ground Port. At *RST, no channel is ground-enabled. The ground
mode is set by “[:ROUTe]:AGND[:STATe]”.
Syntax [:ROUTe]:AGND:CHANnel:DISable:CARD card_number
Example OUTPUT @Agb2200;":ROUT:AGND:CHAN:DIS:CARD ALL"
[:ROUTe]:AGND:CHANnel:DISable[:LIST]
This command specifies the ground-disabled output ports (channels). When the
Ground Mode is ON, the ground-disabled output ports are disconnected from the
input Ground Port. At *RST, no channel is ground-enabled. The ground mode is set
by “[:ROUTe]:AGND[:STATe]”.
The query returns whether the specified channels are ground-disabled or not.
Syntax [:ROUTe]:AGND:CHANnel:DISable[:LIST] (@channel_list)
[:ROUTe]:AGND:CHANnel:DISable[:LIST]? (@channel_list)
Input port is always the input Ground Port. So, the input ports in channel_list are
ignored. However, you cannot abbreviate the input port.
Query response disable_status{, disable_status} <newline><^END>
1: ground disabled
0: ground enabled
Parameter Explanation
card_number For Auto Config mode: 0 or ALL
For Normal Config mode: 1, 2, 3, 4, or ALL
Parameter Explanation
channel_list Channels to ground-disable or to check.
For channel_list, see “Switch Control” on page 4-5.