Agilent Technologies Agilent B2201A - Manual (Page 153)

Agilent B2200 User’s Guide, Edition 4 5-25
SCPI Command Reference
[:ROUTe]:AGND:CHANnel:ENABle:CARD
Example OUTPUT @Agb2200;":ROUT:AGND:CHAN:DIS (@10101)"
OUTPUT @Agb2200;":ROUT:AGND:CHAN:DIS? (@10101,10102,10201)"
ENTER @Agb2200;A$
This example ground-disables the output port 1 on the card 1. In this example, A$
will be 1,0,1.
[:ROUTe]:AGND:CHANnel:ENABle:CARD
This command ground-enables the all output ports (channels) for the specified card.
When the Ground Mode is ON, the ground-enabled output ports that have not been
connected to any other input port are connected to the input Ground Port. This
command is available only for the specified card. At *RST, no channel is
ground-enabled. The ground mode is set by “[:ROUTe]:AGND[:STATe]”.
Syntax [:ROUTe]:AGND:CHANnel:ENABle:CARD card_number
Example OUTPUT @Agb2200;":ROUT:AGND:CHAN:ENAB:CARD ALL"
[:ROUTe]:AGND:CHANnel:ENABle[:LIST]
This command specifies the ground-enabled output ports (channels). When the
Ground Mode is ON, the ground-enabled output ports that have not been connected
to any other input port are connected to the input Ground Port. Then, the input
Ground Port will not be connected to the output ports that have been connected to
any other input port. At *RST, no channel is ground-enabled. The ground mode is
set by “[:ROUTe]:AGND[:STATe]”.
The query returns whether the specified channels are ground-enabled or not.
Syntax [:ROUTe]:AGND:CHANnel:ENABle[:LIST] (@channel_list)
[:ROUTe]:AGND:CHANnel:ENABle[:LIST]? (@channel_list)
Parameter Explanation
card_number For Auto Config mode: 0 or ALL
For Normal Config mode: 1, 2, 3, 4, or ALL
Parameter Explanation
channel_list Channels to ground-enable or to check.
For channel_list, see “Switch Control” on page 4-5.