Agilent Technologies Agilent B2201A - Manual (Page 157)

Agilent B2200 User’s Guide, Edition 4 5-29
SCPI Command Reference
[:ROUTe]:BIAS:CHANnel:DISable:CARD
[:ROUTe]:BIAS:CHANnel:DISable:CARD
This command bias-disables the all output ports (channels) for the specified card.
When the Bias Mode is ON, the bias-disabled output ports are disconnected from
the input Bias Port. At *RST, all cards are bias-enabled. The bias mode is set by
“[:ROUTe]:BIAS[:STATe]”.
Syntax [:ROUTe]:BIAS:CHANnel:DISable:CARD card_number
Example OUTPUT @Agb2200;":ROUT:BIAS:CHAN:DIS:CARD ALL"
[:ROUTe]:BIAS:CHANnel:DISable[:LIST]
This command specifies the bias-disabled output ports (channels). When the Bias
Mode is ON, the bias-disabled output ports are disconnected from the input Bias
Port. At *RST, all channels are bias-enabled. The bias mode is set by
“[:ROUTe]:BIAS[:STATe]”.
The query returns whether the specified channels are bias-disabled or not.
Syntax [:ROUTe]:BIAS:CHANnel:DISable[:LIST] (@channel_list)
[:ROUTe]:BIAS:CHANnel:DISable[:LIST]? (@channel_list)
Input port is always the input Bias Port. So, the input ports in channel_list are
ignored. However, you cannot abbreviate the input port.
Query response disable_status{, disable_status} <newline><^END>
1: bias disabled
0: bias enabled
Parameter Explanation
card_number For Auto Config mode: 0 or ALL
For Normal Config mode: 1, 2, 3, 4, or ALL
Parameter Explanation
channel_list Channels to bias-disable or to check.
For channel_list, see “Switch Control” on page 4-5.