AT&T System 85 - Manual (Page 37)

CHAPTER 4. OPERATING PROCEDURES
5.
6.
7.
8.
9.
10.
Press [START] , and dial AAR/ARS access code.
Listen for dial tone, busy tone, or audio:
Dial tone—trunk is connected. Go to Step 9.
Busy tone—no trunk available, and queuing is not available. Go to Step 10.
Audio (music or recorded announcement)—call is placed in queue because no
outgoing trunks are available. Refer to “Queuing” under “Outgoing Calls” for
information on how to handle the call.
If you use direct trunk group selection to select a trunk, do Step 7. If you do not use
direct trunk group selection, go to Step 8.
Press direct trunk group select button.
Listen for dial tone, busy tone, or audio.
Dial tone—trunk is connected. ANS light goes on. Go to Step 9.
Busy tone—no trunk available, and queuing is not available. Go to Step 10.
Audio (music or recorded announcement)—call is placed in queue because
outgoing trunks are available. Refer to “Queuing” under “Outgoing Calls”
information on how to handle the call.
Press [START] , and dial the Trunk Group access code.
Listen for dial tone, busy tone, or audio:
Dial tone—trunk is connected. ANS light goes on. Go to Step 9.
Busy tone—no trunk available, and queuing is not available. Go to Step 10.
Audio (music or recorded announcement)—call is placed in queue because
outgoing trunks are available. Refer to “Queuing” under “Outgoing Calls”
information on how to handle the call.
no
for
no
for
Press [RELEASE] .
Display, ANS, ATND, and SPLIT lights go off. PA light goes on. Caller is connected
to the trunk, and dials the outside number to complete the call.
Press [CANCL] .
Busy tone stops. ANS and SPLIT lights go off.
4-15