AT&T System 85 - Manual (Page 47)

CHAPTER 4. OPERATING FEATURES
Attendant Control of Trunk Group Access
Allows you to control access to a maximum of
users to the trunk groups under your control
display shows ACTG (Attendant Control of Trunk 12 trunk groups. Calls from voice terminal
are routed to your console. Alphanumeric
Group).
To activate Attendant Control of Trunk Group Access:
1.
2.
3.
4.
5.
6.
Press an idle loop button.
ATND light goes on. PA light goes off.
Press [START] , and dial Activate Code.
Listen for dial tone.
If you use direct trunk group selection to select trunks, do Step 4. If you do not use
direct trunk group selection, go to Step 5.
Press direct trunk group select button of trunk group to be controlled.
Listen for tone:
Confirmation tone—you control the trunk group. CONT light goes on four the specified
trunk group. Go to Step 6.
Intercept tone—trunk group is already controlled by you. Go to Step 6.
Dial Trunk Group access code of trunk group to be controlled.
Listen for tone:
Confirmation tone—you control the trunk group. CONT light goes on for specified
trunk group.
Intercept tone—trunk group is already controlled by you.
Press [RELEASE] .
ATND light goes off. PA light goes on. CONT light goes on as long as you have
control of the trunk group access.
To cancel Attendant Control of Trunk Group Access:
1. Press an idle loop button.
ATND light goes on. PA light goes off.
4-25