AT&T System 85 - Manual (Page 89)

CHAPTER 4. OPERATING FEATURES
4.
5.
6.
7.
Press [VERFY] .
Listen for recall dial tone (three short bursts of tone, then dial tone).
Dial the trunk group access code for the trunk to be verified.
Dial the trunk number.
VERFY light may or may not go off. ANS light goes on if the trunk you are connected
to is other than a tie trunk. RING light goes on if you are connected to a tie trunk.
Listen for tone:
Warning tone— starts before connection to a busy number to ensure user privacy.
Trunk is busy if you hear conversation after the tone. Trunk may be out of order or
holding a call if you do not hear conversation after the tone.
Reorder tone— BUSY light goes on. Feature is temporarily denied because the trunk
is being held or is in some other transient state.
Intercept tone—feature is permanently denied.
Press [RELEASE] .
ATND and VERFY lights go off. PA light goes on.
Unattended Console Service
Allows you to route incoming calls to an alternate console whenever your console is
unattended. Also allows you to route incoming trunk calls, intended for your console, to
several designated extension numbers, or to one specific extension number.
To activate or cancel routing of calls to an alternate console:
1. Push the external alternate console switch.
All calls are routed to the alternate console, or calls are no longer routed to the
alternate console.
To set up trunk-to-telephone/voice terminal assignments:
You can route calls on an incoming trunk to a designated extension number when you set up
trunk-to-telephone/voice terminal assignments.
1. Press an idle loop button.
ATND light goes on.
4-67