HP LaserJet 4250 - Manual (Page 120)

2. Use ( U
P
button) or ( D
OWN
button) to scroll to INFORMATION, and then press
( S
ELECT
button).
3. Use ( U
P
button) or ( D
OWN
button) to scroll to PRINT PS FONT LIST or PRINT PCL
FONT LIST, and then press ( S
ELECT
button).
The PS font list shows the PS fonts that are installed, and gives a sample of those fonts. The
following information can be found on the PCL font list:
● Font gives the font names and samples.
● Pitch/Point indicates the pitch and point size of the font.
● Escape Sequence (a PCL programming command) is used to select the designated
font. (See the legend at the bottom of the font list page.)
NOTE For information about using printer commands to select a font with MS-DOS ® programs, see
Selecting PCL 6 and PCL 5 fonts .
● Font # is the number used to select fonts at the printer control panel (not in the
program). Do not confuse the font # with the font ID. The number indicates the
CompactFlash slot where the font is stored.
● SOFT: Downloaded fonts, which stay resident in the printer until other fonts are
downloaded to replace them, or until the printer power is turned off.
● INTERNAL: Fonts that permanently reside in the printer.
● Font ID is the number you assign to soft fonts when you download them through
software.
108 Chapter 3 Managing and maintaining the printer ENWW