HP LaserJet 4250 - Manual (Page 28)

To set the job storage limit
1. Press M
ENU
to open the menus.
2. Press ( D
OWN
button) to highlight CONFIGURE DEVICE.
3. Press ( S
ELECT
button) to select CONFIGURE DEVICE.
4. Press ( D
OWN
button) to highlight SYSTEM SETUP.
5. Press ( S
ELECT
button) to select SYSTEM SETUP.
6. Press ( S
ELECT
button) to select JOB STORAGE LIMIT.
7. Press ( U
P
button) or ( D
OWN
button) to change the value.
8. Press ( S
ELECT
button) to set the value.
9. Press M
ENU
to exit the menu.
Job held timeout
This option sets the period of time that the system keeps files in job storage before deleting
them from the queue. The default setting for this option is OFF; the other available settings
are 1 HOUR, 4 HOURS, 1 DAY, and 1 WEEK.
NOTE This option is only available if a hard drive is installed.
To set the job held timeout
1. Press M
ENU
to open the menus.
2. Press ( D
OWN
button) to highlight CONFIGURE DEVICE.
3. Press ( S
ELECT
button) to select CONFIGURE DEVICE.
4. Press ( D
OWN
button) to highlight SYSTEM SETUP.
5. Press ( S
ELECT
button) to select SYSTEM SETUP.
6. Press ( D
OWN
button) to highlight JOB HELD TIMEOUT.
7. Press ( S
ELECT
button) to select JOB HELD TIMEOUT.
8. Press ( U
P
button) or ( D
OWN
button) to select the appropriate time period.
9. Press ( S
ELECT
button) to set the time period.
10. Press M
ENU
to exit the menu.
Show address
This item determines whether the printer's IP address appears on the display with the Ready
message. If more than one EIO card is installed, the IP address of the card that is installed in
the first slot appears.
16 Chapter 1 Printer basics ENWW