HP LaserJet 4250 - Manual (Page 261)

Checking memory installation
After installing the DIMM or CompactFlash card, make sure that the installation was
successful.
To verify that DIMMs or CompactFlash cards are installed
correctly
1. Check that Ready appears on the printer control panel display when the printer power is
turned on. If an error message appears, a DIMM or CompactFlash card might have been
incorrectly installed. See
Interpreting control-panel messages .
2. Print a new configuration page. (See Configuration page .)
3. Check the memory section on the configuration page and compare it to the configuration
page that was printed before the memory installation. If the amount of memory has not
increased, the DIMM or CompactFlash card might not be installed correctly, or the DIMM
or CompactFlash card might be defective. Repeat the installation procedure. If
necessary, install a different DIMM or CompactFlash card.
NOTE If you installed a printer language (personality), check the "Installed Personalities and
Options" section on the configuration page. This area should list the new printer language.
ENWW Checking memory installation 249