HP LaserJet 4250 - Manual (Page 36)

To set the jam-recovery response
1. Press M
ENU
to open the menus.
2. Press ( D
OWN
button) to highlight CONFIGURE DEVICE.
3. Press ( S
ELECT
button) to select CONFIGURE DEVICE.
4. Press ( D
OWN
button) to highlight SYSTEM SETUP.
5. Press ( S
ELECT
button) to select SYSTEM SETUP.
6. Press ( D
OWN
button) to highlight JAM RECOVERY.
7. Press ( S
ELECT
button) to select JAM RECOVERY.
8. Press ( U
P
button) or ( D
OWN
button) to select the appropriate setting.
9. Press ( S
ELECT
button) to set the selection.
10. Press M
ENU
to exit the menu.
RAM disk
This option determines how the RAM disk feature is configured. This option is only available
if no hard disk is installed and the printer has at least 8 MB of free memory. The default is
AUTO.
● AUTO. The printer determines the optimal RAM disk size based on the amount of
available memory.
● OFF. The RAM disk is disabled, but a minimal RAM disk is still active (sufficient to scan
one page).
To set the RAM disk
1. Press M
ENU
to open the menus.
2. Press ( D
OWN
button) to highlight CONFIGURE DEVICE.
3. Press ( S
ELECT
button) to select CONFIGURE DEVICE.
4. Press ( D
OWN
button) to highlight SYSTEM SETUP.
5. Press ( S
ELECT
button) to select SYSTEM SETUP.
6. Press ( D
OWN
button) to highlight RAM DISK.
7. Press ( S
ELECT
button) to select RAM DISK.
8. Press ( U
P
button) or ( D
OWN
button) to select the appropriate setting.
9. Press ( S
ELECT
button) to set the selection.
10. Press M
ENU
to exit the menu.
Language
If LANGUAGE appears in English on the control panel, use the following procedure.
Otherwise, turn the printer off and then on again. When XXX MB appears, press and hold
(
S
ELECT
button). When all three control panel lights are lit, release ( S
ELECT
button) and use
the following procedure to set the language.
24 Chapter 1 Printer basics ENWW