HP LaserJet 4250 - Manual (Page 176)

Control panel message Description Recommended action
RAM DISK DEVICE
FAILURE
To clear press
alternates with
<current status
message>
The RAM disk had a critical failure and
can no longer be used. Contact an HP-authorized service or
support provider.
RAM DISK FILE
OPERATION FAILED
To clear press
alternates with
<current status
message>
The requested operation could not be
performed. You might have attempted
an illegal operation, such as trying to
download a file to a non existent folder. Try printing again to an existing folder.
RAM DISK FILE
SYSTEM IS FULL
To clear press
alternates with
<current status
message>
The RAM disk is full. 1. Delete files and then try again, or
turn the printer power off, and then
turn the printer power on to delete
all files on the device. (Use Device
Storage Manager in HP Web
Jetadmin or another software utility
to delete the files.
2. If the message persists, increase
the size of the RAM disk. Change
the RAM disk size on the System
Setup submenu (on the Configure
Device menu) at the printer control
panel. See the description of the
RAM disk menu items in System
Setup submenu.
RAM DISK IS
WRITE PROTECTED
To clear press
alternates with
<current status
message>
The RAM disk is protected, and no new
files can be written to it. Use the Device Storage Manager in
HP Web Jetadmin to disable the write
protection.
RAM DISK NOT
INITIALIZED
To clear press
alternates with
<current status
message>
The file system has not been initialized. Use HP Web Jetadmin to initialize the
file system.
REINSERT DUPLEXER The duplexer has been removed. Reinsert the duplexer.
Interpreting control-panel messages (continued)
164 Chapter 4 Problem solving ENWW