HP LaserJet 4250 - Manual (Page 31)

To set the printer default for PS Defer Media
1. Press M
ENU
to open the menus.
2. Press ( D
OWN
button) to highlight CONFIGURE DEVICE.
3. Press ( S
ELECT
button) to select CONFIGURE DEVICE.
4. Press ( D
OWN
button) to highlight SYSTEM SETUP.
5. Press ( S
ELECT
button) to select SYSTEM SETUP.
6. Press ( D
OWN
button) to highlight TRAY BEHAVIOR.
7. Press ( S
ELECT
button) to select TRAY BEHAVIOR.
8. Press ( S
ELECT
button) to select PS DEFER MEDIA.
9. Press ( U
P
button) or ( D
OWN
button) to select ENABLED or DISABLED.
10. Press ( S
ELECT
button) to set the behavior.
11. Press M
ENU
to exit the menu.
To set Size/type prompt
1. Press M
ENU
to open the menus.
2. Press ( D
OWN
button) to highlight CONFIGURE DEVICE.
3. Press ( S
ELECT
button) to select CONFIGURE DEVICE.
4. Press ( D
OWN
button) to highlight SYSTEM SETUP.
5. Press ( S
ELECT
button) to select SYSTEM SETUP.
6. Press ( D
OWN
button) to highlight TRAY BEHAVIOR.
7. Press ( S
ELECT
button) to select TRAY BEHAVIOR.
8. Press ( S
ELECT
button) to select SIZE/TYPE PROMPT.
9. Press ( U
P
button) or ( D
OWN
button) to select DISPLAY or DO NOT DISPLAY.
10. Press ( S
ELECT
button) to set the behavior.
11. Press M
ENU
to exit the menu.
Sleep Delay
The adjustable Sleep Delay feature reduces power consumption when the printer has been
inactive for an extended period. You can set the length of time before the printer goes into
sleep mode to 1 MINUTE, 15 MINUTES, 30 MINUTES, or to 60 MINUTES, 90 MINUTES, 2
HOURS, or 4 HOURS. The default setting is 30 MINUTES.
NOTE The printer control-panel display dims when the printer is in sleep mode. Sleep mode does
not affect printer warm-up time unless the printer was in sleep mode for more than 8 hours.
ENWW Control panel 19