Clearing jams from the fuser area, Clearing, Jams from the fuser area – HP LaserJet 4250 User Manual
Page 154
Clearing jams from the fuser area
Use this procedure only in these situations:
●
Media has jammed inside the fuser and cannot be removed from the top-cover area or
the rear-output area.
●
A sheet of media has torn while you were trying to clear a jam from the fuser.
To clear jams from the fuser area
1. Turn the printer power off and unplug the power cord from the printer.
WARNING!
The fuser is very hot. To avoid minor burns, wait 30 minutes for the fuser to cool before
removing it from the printer.
2. Turn the printer so that its rear cover faces you. If it is installed, remove the optional
duplexer by lifting it up and then pulling it out.
3. Open the rear output bin and pull the extension outward until it stops.
4. Remove the rear output bin and extension by bending the middle of the bin down and
releasing the two hinge pins.
2
1
2
142
Chapter 4 Problem solving
ENWW