HP LaserJet 4250 - Manual (Page 232)

Item Values Explanation
TONER
DENSITY
1 to 5 (*3) Lighten or darken the print on the page by
setting the toner density. Select a setting ranging
from 1 (light) to 5 (dark). The default setting of 3
usually produces the best results.
NOTE
It is best to change the toner density in the
program or printer driver. (Program and printer
driver settings override control-panel settings.)
SMALL PAPER MODE *NORMAL
SLOW
Select SLOW to prevent jams when printing on
narrow media, as the part of the fuser rollers that
do not make contact with the media swell up,
which can cause wrinkles.
AUTO
CLEANING
*OFF
ON
Clean the fuser automatically by using this
feature. This setting is unavailable if an optional
duplexer is installed. If a duplexer is installed,
run the cleaning page manually. See CREATE
CLEANING PAGE below and
Cleaning the fuser .
CLEANING
INTERVAL
1000*
2000
5000
10000
20000
If auto cleaning is on, set how often it runs. The
intervals correspond to the number of pages that
the printer has printed. This setting is
unavailable if an optional duplexer is installed.
AUTO
CLEANING SIZE
*LETTER
A4
If auto cleaning is on, set the size of paper that
the printer should use when it is cleaning the
printer automatically. This setting is unavailable
if an optional duplexer is installed.
CREATE
CLEANING PAGE
There is no value to
select. Press ( S
ELECT
button) to print a cleaning page
manually (for cleaning toner from the fuser).
Open the rear output bin. Follow the instructions
on the cleaning page. For more information, see
Cleaning the fuser .
PROCESS
CLEANING PAGE
There is no value to
select. This item is available only after a cleaning page
has been created. Follow the instructions that
are printed on the cleaning page. The cleaning
process might take up to 2.5 minutes.
System Setup submenu
Items on this menu affect printer behavior. Configure the printer according to your printing
needs.
The section that follows lists the settings and possible values. In the Values column, the
default value for each setting is the one with an asterisk (*) next to it.
220 Appendix B Control panel menus ENWW