HP ProLiant ML370 G5 Server - Manual (Page 26)

Operations 26
1. Extend the server from the rack, if applicable (" Extend the server from the rack " on page 22 ).
2. Open the locking latch, slide the access panel to the rear of the chassis, and remove the access
panel.
NOTE: If the locking latch is locked, use a Torx T-15 screwdriver to unlock the latch.
Install the access panel
1. Place the access panel on top of the server with the hood latch open. Allow the panel to extend past
the rear of the server approximately 0.8 cm (0.2 in).
2. Engage the anchoring pin with the corresponding hole in the latch.
3. Push down on the hood latch. The access panel slides to a closed position.
Remove the processor air baffle
1. Power down the server (on page 20 ).
2. Extend or remove the server from the rack (" Extend the server from the rack " on page 22 ).
3. Remove the access panel (on page 25 ).