HP ProLiant ML370 G5 Server - Manual (Page 67)

Hardware options installation 67
Tower-to-rack conversion option
The tower-to-rack conversion kit includes all equipment required to convert the tower model server into a
rack model server and to install the server into most square- or round-hole racks.
The tower-to-rack conversion kit includes:
• Rack rails
• Cable management arm
• Server rails
• Rack bezel
• Front video connector cable
In addition to the items supplied in the conversion kit, you will also need a Torx T-15 screwdriver (clipped
to the rear panel of the server).
To convert a tower server to a rack server:
1. Power down the server (on page 20 ).
2. Remove the feet.
3. Remove the tower bezel (" Open or remove the tower bezel " on page 21 ).
4. Remove the tower configuration panels:
a. Use the T-10/T-15 Torx screwdriver to remove the two front panel screws.