HP ProLiant ML370 G5 Server - Manual (Page 54)

Hardware options installation 54
9. Slide the hard drive cage into the drive bay and insert the four screws to secure the drive cage to the
chassis.
10. Connect the two SAS-SATA data cables to the drive cage backplane.
IMPORTANT: When installing a x3/x1 SAS cable, HP recommends that the x3 part of the
x3/x1 cable be linked to the SAS hard drive backplane connector that corresponds to hard
drive slots 1 to 4. In this setup, hard drive slot 1 will not be available, but since hard drive slots
2 to 4 will be connected, one continuous volume can be created.
11. Connect the 10-pin power cable to the drive cage backplane.
NOTE: The center wall is removed for illustration purposes only.