HP ProLiant ML370 G5 Server - Manual (Page 65)

Hardware options installation 65
To remove the component:
1. Power down the server (on page 20 ).
2. Extend the server from the rack, if applicable (" Extend the server from the rack " on page 22 ).
3. Remove the access panel (on page 25 ).
4. Disconnect any cables attached to the expansion board.
5. Release the retainer clip.
6. Press the slot release lever and swing the slot release lever upward.
7. Remove the expansion board.
CAUTION: Make a note of board locations. Be sure to install replacements in the same slots.