HP StorageWorks XP Remote Web Console Software - Manual (Page 114)

1. Make sure the remote copy connections and ports are properly configured. Also, get the serial
number of the remote storage system.
To get the serial number of the remote storage system, ask the administrator of the remote storage
system. The serial number will be displayed in the XP Remote Web Console main window when
the XP Remote Web Console user logs into the storage system.
2. Ensure that the XP Remote Web Console main window is in Modify mode.
For detailed information about how to do this, please refer to XP Remote Web Console User’s Guide.
3. Ensure that the DKC Operation window is displayed.
4. In Display, select DKC.
5. Select LDKC from the tree.
6. Right-click the upper-right list, and then select DKC Operation and Add DKC
The Add DKC window appears (refer to
Figure 50 on page 115).
7. In the Add DKC window, enter the following:
• the serial number of the remote storage system
• the LDKC number of the remote storage system “00” is displayed when the remote storage
system is XP12000/XP10000/SVS 200 Disk Array.
• the controller ID of the remote storage system (model name that indicates the model)
NOTE:
The controller ID for an XP storage system is 4.
• the path group ID
The path group ID is within the range of 1-FF (hexadecimal). Up to 64 path group IDs can be
registered per storage system. In the current version, the path group IDs always take the default
values and cannot be changed
8. In the Add DKC window, select a primary storage system port and a remote storage system port
to configure a logical path.
9. Select Option.
10. In the DKC Option window, configure logical path options and storage system options.
For detailed information about the options, see
Chapter 5 on page 123 and read explanations
below Figure 51 on page 116.
11. Select Set to close the DKC Option window.
12. See the Preview list to check the settings that you have made.
• If you want to modify a setting, select and right-click the setting from the Preview list and then
select Modify. A window appears and allows you to modify the setting.
• If you want to cancel a setting, select and right-click the setting in the Preview list and then
select Cancel.
13. Select Apply to apply the settings that you have made. If an error occurs, the rightmost column of
the Preview list displays the error code. To view detailed information about the error, right-click
the error code and then select Error Detail. An error message appears and gives you detailed
information about the error.
114 Configuring Disk Storage Systems and Logical Paths