HP StorageWorks XP Remote Web Console Software User Manual
Page 144
5.
From the mirrors, select and right-click the mirror(s) that you want to restore.
When you select the mirror in Stop status, the copying of data will be restarted after the recovery.
The result of this operation differs according to the status of the selected mirror.
• When
you
select
the
mirror
in
Stop status, the copying of data will be restarted after the
recovery.
• When
you
select
the
mirror
in
Hold status, delta resync operation will be performed after the
recovery.
• When
you
select
the
mirror
in
Hold(Failure) status, the status will change to Hold after the
recovery.
6.
From the pop-up menu, select JNL Groups and Resume Pair.
7.
See the Preview list to check the mirrors that you want to restore.
• If you want to cancel restoring a mirror, select and right-click the mirror and then select Cancel.
• If necessary, you can repeat steps 3–7 beginning
on page 143 to specify other mirrors.
8.
Select Apply to restore the mirror(s).
NOTE:
If an error occurs, the rightmost column of the Preview list displays the error code. To view detailed
information about the error, right-click the error code and then select Error Detail. An error message
appears and gives you detailed information about the error.
Deleting Data Volumes from a Mirror (Ending a copy
operation)
A mirror is a combination of a master journal group and a restore journal group. If you delete data
volumes (i.e., the primary data volume and the secondary data volume) from a mirror, the copying of
data from the master journal group to the restore journal group will end.
To delete data volumes from a mirror, follow the procedure below. Not only the primary storage system
administrator but also the secondary storage system administrator can perform this operation:
1.
Ensure that the XP Remote Web Console main window is in Modify mode.
For detailed information about how to do this, please refer to XP Remote Web Console User’s Guide.
2.
Ensure that the Journal Operation window is displayed.
3.
Do either of the following:
• In the tree, select a master journal group ( ) or a restore journal group ( ) from below
Registered.
• In the tree, select Journal Groups or Registered and then select a master journal group ( ) or
a restore journal group ( ) from the list to the right.
The list displays a list of mirrors. One row in the list represents one mirror.
4.
Locate mirrors that are not in Initial status.
5.
From the mirrors, select and right-click the mirror(s) from which you want to delete data volumes.
6.
From the pop-up menu, select JNL Groups and Delete Pair.
7.
See the Preview list to check the settings that you have made.
• If you want to cancel a setting, select and right-click the setting and then select Cancel.
• If necessary, you can repeat steps
on page 144 to specify other mirrors.
8.
Select Apply to delete data volumes from the mirror(s).
144
Using Journal Groups