HP LaserJet 4050 Printer series User Manual
Page 127
EN
Chapter 4: Problem Solving
105
EIO n DISK
INITIALIZING
The disk accessory card takes a long time to initialize. The first
parameter is the accessory slot number for this disk accessory card.
EIO n DISK
NOT FUNCTIONAL
The EIO disk is not working correctly.
Remove the EIO disk from the slot indicated.
Replace it with a new EIO disk.
EIO n
INITIALIZING
alternates with
DO NOT POWER OFF
Wait for the message to disappear (approximately 5 minutes). If the
printer EIO card is operating correctly and communicating with the
network, this message disappears after approximately one minute
and no action is required.
If the EIO card is unable to communicate with the network, this
message remains for five minutes and then disappears. In this case
the printer is not communicating with the network (even though the
message is no longer present). The problem may be a bad EIO card,
a bad cable or connection on the network, or a network problem.
Contact your network administrator.
EIO n DISK
SPINNING UP
The disk accessory is initializing. The first parameter is the accessory
slot number for this accessory card.
ENV FEEDER LOAD
[TYPE] [SIZE]
Load the requested envelope type and size into the envelope feeder.
Make sure the envelope size and type are set correctly from the Paper
Handling Menu in the printer’s control panel (page B-5).
Press
[Go]
if the desired envelope is already loaded in the feeder.
Press
[- Value +]
to scroll through the available types and sizes. Press
[Select]
to accept the alternate type or size.
EXTERNAL DEVICE
INITIALIZING
When an external paper handling device is connected to the printer,
it must initialize after the computer boots or after coming out of
PowerSave mode.
FLASH DEVICE
FAILURE
The flash DIMM had a critical failure and no longer can be used.
Remove the flash DIMM and replace it with a new one.
FLASH FILE
OPERATION FAILED
The requested operation could not be performed. You might have
attempted an illegal operation, such as trying to download a file to a
non-existent directory.
FLASH FILE
SYSTEM IS FULL
Delete files from the flash DIMM. Use HP Resource Manager to
download or delete files and fonts. (See the software help for more
information.)
FLASH IS
WRITE PROTECTED
The flash DIMM is protected and no new files can be written to it.
Disable the write protection through HP Resource Manager.
Printer Messages (Continued)
Message
Explanation or Recommended Action