HP LaserJet 4050 Printer series - Manual (Page 129)

EN
Chapter 4: Problem Solving 107
OUTPUT BIN FULL
CLEAR (BIN nnn)
nnn = (bin name)
The output bin is full and needs to be emptied.
PERFORM PRINTER
MAINTENANCE To ensure optimum print quality, the printer prompts you to perform
routine maintenance every 200,000 pages. To order a Printer
Maintenance Kit, see page (page 11). (For more information see
page 87.)
RAM DISK DEVICE
FAILURE The RAM disk had a critical failure and can no longer be used.
Turn the printer off, and then turn the printer on to clear the message.
RAM DISK FILE
OPERATION FAILED The requested operation could not be performed. You might have
attempted an illegal operation, such as trying to download a file to a
non-existent directory.
RAM DISK FILE
SYSTEM IS FULL Delete files and then try again, or turn the printer off, and then turn
the printer on to delete all files on the device. (Delete files using HP
Resource Manager or another software utility. See the software help
for more information.)
If the message persists, increase the size of the RAM disk. Change
the RAM disk size from the Configuration Menu in the printer’s control
panel (page B-14). HP Resource manager can also be used to
increase/decrease the RAM disk size.
TONER LOW See page 80.
TRAY x EMPTY Load the empty tray ( x ) to clear the message.
If you do not load the specified tray, the printer will continue printing
from the next available tray, and the message will continue to display.
TRAY x LOAD
[TYPE] [SIZE]
(or similar messages
requesting that you
load paper)
Load the requested paper into the specified tray ( x ). (See the sections
on loading paper, starting on page 34)
Make sure that the trays are correctly adjusted for size.The tray type
settings (and size for Tray 1) must be set from the printer’s control
panel (page 65).
Load the requested paper into an indicated tray, or press [Select] to
override the message and to print on a loaded paper size.
If printing does not continue, press [Go] .
If you are trying to print A4 or letter size paper and this message
appears, make sure the default paper size is set correctly from the
Printing Menu in the printer’s control panel.
Press [Go] to print from the next available tray.
Press [- Value +] to scroll through the available types and sizes.
Press [Select] to accept the alternate type or size.
UNABLE TO
MOPY JOB Memory or file system failures would not allow a mopy job to occur.
Only one copy will be produced.
Printer Messages (Continued)
Message Explanation or Recommended Action